CP2102-IC is a highly integrated USB to UART Bridge Controller providing a simple solution for updating RS-232 designs to USB using a minimum of components and PCB space. The CP2102-GM includes a USB 2.0 full-speed function controller, USB transceiver, oscillator, EEPROM, and asynchronous serial data bus (UART) with full modem control signals. No other external USB components are required. The on-chip EEPROM may be used to customize the USB Vendor ID, Product ID, Product Description String, Power Descriptor, Device Release Number, and Device Serial Number as desired for OEM applications. The EEPROM is programmed on board via the USB, allowing the programming step to be easily integrated into the product manufacturing and testing process.
- Integrated USB transceiver; no external resistors required
- Integrated clock; no external crystal required
- Integrated 1024 Byte EEPROM
- On-chip power-on reset circuit
- On-chip voltage regulator: 3.3V output
- USB Specification 2.0 compliant; full-speed (12 Mbps)
- USB suspend states supported via SUSPEND pins
- All handshaking and modem interface signals
- Baud rates: 300 bps to 1 Mbits
- 576 Byte receive buffer; 640 byte transmit buffer
- Hardware or X-On/X-Off handshaking supported
- Event character support
- Line break transmission
Applications
Communications & Networking, Consumer Electronics, Aerospace, Defence, Military, Multimedia
Features:- CP2102 IC
- Integrated USB transceiver; no external resistors required
- Integrated clock; no external crystal required
- Internal 1024-byte programmable ROM for vendor ID, product ID, serial number, power descriptor, release
- number, and product description strings
- On-chip power-on reset circuit
- On-chip voltage regulator – 3.3 V output (CP2102)
Specifications:- CP2102 IC
- Parameter Min Max Unit
- Ambient Temperature under Bias TBIAS -55 125 ?C
- Storage Temperature TSTG -65 150 ?C
- The voltage on VDD with respect to GND VDD -0.3 4.2 V
- Maximum Total Current through VDD and GND – 500 mA
- Maximum Output Current sunk by RST or any I/O pin – 100 mA
